Clear Ets Counters - Dell MXL 10GbE Reference Manual

sum of configured bandwidth allocation to dot1p priority traffic in all ETS priority
groups must be 100%. Allocate at least 1% of the total bandwidth to each priority
group and queue. If bandwidth is assigned to some priority groups but not to
others, the remaining bandwidth (100% minus assigned bandwidth amount) is
equally distributed to nonstrict-priority groups which have no configured
scheduler.
Related
•
Commands
•

clear ets counters

Clear all ETS TLV counters on an interface.
Syntax
clear ets counters port-type slot/port
Parameters
port-type
Defaults none
Command EXEC Privilege
Modes
Command
Version 9.3(0.0)
History
dcb-map
Create a DCB map to configure priority flow control (PFC) and enhanced transmission selection (ETS) on
Ethernet ports that support converged Ethernet traffic. Apply the DCB map to an Ethernet interface.
Syntax
dcb-map map-name
Parameters
map-name
Defaults None.
Command CONFIGURATION
Modes
INTERFACE
Command
Version 9.3(0.0)
History
1386
qos-policy-output ets — creates a QoS output policy.
scheduler — schedules priority traffic in port queues.
Enter the keywords port-type then the slot/port
information.
Introduced on the FC Flex IO module installed in the MXL
10/40GbE Switch.
Enter a DCB map name. The maximum number of
alphanumeric characters is 32.
Introduced on the FC Flex IO module installed in the MXL
10/40GbE Switch.
FC Flex IO Modules