Debug Uplink-State-Group - Dell MXL 10GbE Reference Manual

Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
Version
8.3.19.0
Version
8.3.12.0
Version 8.4.2.3
Related
•
Commands
•

debug uplink-state-group

Enable debug messages for events related to a specified uplink-state group or all groups.
Syntax
debug uplink-state-group [group-id]
To turn off debugging event messages, enter the no debug uplink-state-
group [group-id] command.
Parameters
group-id
Defaults none
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
Version
8.3.19.0
PMUX Mode of the MXL 10/40GbE Switch I/O Module
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the S-Series S50.
downstream — assigns a port or port-channel to the uplink-state group as a
downstream interface.
uplink-state-group — creates an uplink-state group and enables the tracking of
upstream links.
Enables debugging on the specified uplink-state group. The
valid group-id values are from 1 to 16.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S4820T.
1521