Table of Contents
Advertisement
net
To configure an IS-IS network entity title (NET) for a routing process, use this mandatory command. If
you did not configure a NET, the IS-IS process does not start.
Syntax
net network-entity-title
To remove a net, use the no net network-entity-title command.
Parameters
network-
entity-title
Defaults
Not configured.
Command
ROUTER ISIS
Modes
Command
Version 9.2(0.0)
History
passive-interface
Suppress routing updates on an interface. This command stops the router from sending updates on that
interface.
Syntax
passive-interface interface
To delete a passive interface configuration, use the no passive-interface
interface command.
Parameters
interface
Intermediate System to Intermediate System (IS-IS)
Specify the area address and system ID for an IS-IS routing
process. The first 1 to 13 bytes identify the area address. The
next 6 bytes identify the system ID. The last 1 byte is the
selector byte, always identified as zero zero (00). This
argument can be applied to an address or a name.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the following keywords and slot/port or number
information:
•
For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
•
For Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
•
For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
•
For a SONET interface, enter the keyword sonet then the
slot/port information.
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a VLAN, enter the keyword vlan then a number from
1 to 4094.
823
Advertisement
Table of Contents
