Port-Channel-Protocol Lacp - Dell MXL 10GbE Reference Manual

port-channel-protocol lacp

Enable LACP on any LAN port.
Syntax
port-channel-protocol lacp
To disable LACP on a LAN port, use the no port-channel-protocol lacp
command.
Command INTERFACE
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Example
Dell(conf)#interface TenGigabitethernet 3/15
Dell(conf-if-tengig-3/15)#no shutdown
Dell(conf-if-tengig-3/15)#port-channel-protocol lacp
Dell(conf-if-tengig-3/15-lacp)#port-channel 32 mode active
...
Dell(conf)#interface TenGigabitethernet 3/16
Dell(conf-if-tengig-3/16)#no shutdown
Dell(conf-if-tengig-3/16)#port-channel-protocol lacp
Dell(conf-if-tengig-3/16-lacp)#port-channel 32 mode active
show lacp
Display the LACP matrix.
Syntax
show lacp port-channel-number [sys-id | counters]
Parameters
port-channel-
number
sys-id
counters
Defaults Without a Port Channel specified, the command clears all Port Channel counters.
Command
•
Modes
•
Command
Version 8.3.16.1
History
844
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter a port-channel number. The range is from 1 to 128.
(OPTIONAL) Enter the keywords sys-id and the value that
identifies a system.
(OPTIONAL) Enter the keyword counters to display the
LACP counters.
EXEC
EXEC Privilege
Introduced on the MXL 10/40GbE Switch IO Module.
Link Aggregation Control Protocol (LACP)