Disable - Dell MXL 10GbE Reference Manual

disable

Disable the spanning tree protocol globally on the switch.
Syntax
disable
To enable Spanning Tree Protocol, use the no disable command.
Defaults Enabled (that is, the spanning tree protocol is disabled.)
Command SPANNING TREE
Modes
Command
Version 8.3.16.1
History
Related portfast bpdufilter default
Commands
forward-delay
The amount of time the interface waits in the Listening state and the Learning state before transitioning
to the Forwarding state.
Syntax
forward-delay seconds
To return to the default setting, use the no forward-delay command.
Parameters
seconds
Defaults 15 seconds
Command SPANNING TREE
Modes
Command
Version 8.3.16.1
History
Related
max-age
Commands
information.
hello-time
1272
Introduced on the MXL 10/40GbE Switch IO Module.
— enters SPANNING TREE mode.
Enter the number of seconds that the system waits before
transitioning STP to the Forwarding state. The range is from
4 to 30. The default is 15 seconds.
Introduced on the MXL 10/40GbE Switch IO Module.
— changes the wait time before STP refreshes protocol configuration
— changes the time interval between BPDUs.
Spanning Tree Protocol (STP)