Rate-Interval - Dell MXL 10GbE Reference Manual

rate-interval

Configure the traffic sampling interval on the selected interface.
Syntax
rate-interval seconds
Parameters
seconds
Defaults 299 seconds
Command INTERFACE
Modes
Command
Version 8.3.16.1
History
Usage The output of the show interfaces command displays the configured rate
Information
interval, along with the collected traffic data.
Related show interfaces
Commands
show config
Display the interface configuration.
Syntax
show config
Command INTERFACE
Modes
Command
Version 8.3.16.1
History
Example
Dell(conf-if)#show conf
!
interface GigabitEthernet 1/7
Dell(conf-if)#
578
Enter the number of seconds for which to collect traffic data.
The range is from 5 to 299 seconds.
Introduced on the MXL 10/40GbE Switch IO Module.
— displays information on physical and virtual interfaces.
Introduced on the MXL 10/40GbE Switch IO Module.
no ip address
switchport
no shutdown
NOTE: For 0 to 5 seconds, polling occurs every 5
seconds. For 6 to 10 seconds, polling occurs every 10
seconds. For any other value, polling occurs every 15
seconds.
Interfaces