Port-Channel-Protocol Lacp - Dell MXL 10GbE Reference Manual

Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage LACP Modes
Information
Mode
active
passive
off

port-channel-protocol lacp

Enable LACP on any LAN port.
Syntax
port-channel-protocol lacp
To disable LACP on a LAN port, use the no port-channel-protocol lacp
command.
Command INTERFACE
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Example
Dell(conf)#interface TenGigabitethernet 3/15
Dell(conf-if-tengig-3/15)#no shutdown
Dell(conf-if-tengig-3/15)#port-channel-protocol lacp
Dell(conf-if-tengig-3/15-lacp)#port-channel 32 mode active
...
Dell(conf)#interface TenGigabitethernet 3/16
Dell(conf-if-tengig-3/16)#no shutdown
Dell(conf-if-tengig-3/16)#port-channel-protocol lacp
Dell(conf-if-tengig-3/16-lacp)#port-channel 32 mode active
PMUX Mode of the MXL 10/40GbE Switch I/O Module
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
Function
An interface is in an active negotiating state in this mode.
LACP runs on any link configured in the active state and also
automatically initiates negotiation with other ports by
initiating LACP packets.
An interface is not in an active negotiating state in this
mode. LACP runs on any link configured in the passive state.
Ports in a passive state respond to negotiation requests from
other ports that are in active states. Ports in a passive state
respond to LACP packets
An interface cannot be part of a dynamic port channel in off
mode. LACP does not run on a port configured in off mode.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
1495