Ipv4 Routing - Dell MXL 10GbE Reference Manual

IPv4 Routing

The basic IPv4 commands are supported by Dell Networking Operating System (OS).
arp
To associate an IP address with a multicast MAC address in the switch when you configure multicast
mode of the network load balancing (NLB), use the address resolution protocol (ARP).
Syntax
arp ip-address multicast-mac-address interface
To remove an ARP address, use the no arp ip-address command.
Parameters
ip-address
multicast-mac-
address
interface
Defaults Not configured.
Command CONFIGURATION
Modes
Command
Version 9.3(0.0)
History
IPv4 Routing
Enter an IP address in dotted decimal format.
Enter a 48–bit hexadecimal address in MAC address in
nn:nn:nn:nn:nn:nn format for the static MAC address to be
used to switch multicast traffic..
(OPTIONAL) Enter any of the following keywords and slot/
port or number information:
• For the Management interface, enter the keyword
ManagementEthernet then the slot/port information.
The slot range is from 0 to 1 and the port range is 0.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• The interface specified here must be one of the
interfaces configured using the {output-range |
output} interface option with the mac-address-
table static command.
Added the support for association of an IP address with
multicast MAC address on the MXL platform.
22
613