Storm Control
The Dell Networking Operating System (OS) storm control feature allows you to limit or suppress traffic
during a traffic storm.
Storm control is supported on the Dell Networking OS Z-Series S4810 S4820T platforms.
Important Points to Remember
•
Interface commands can only be applied on physical interfaces (virtual local area networks [VLANs]
and link aggregation group [LAG] interfaces are not supported).
•
An INTERFACE-level command only supports storm control configuration on ingress.
•
An INTERFACE-level command overrides any CONFIGURATION-level ingress command for that
physical interface, if both are configured.
•
Do not apply per-VLAN quality of service (QoS) on an interface that has storm control enabled (either
on an interface or globally).
show storm-control broadcast
Display the storm control broadcast configuration.
Syntax
show storm-control broadcast [interface]
Parameters
interface
Defaults
none
Command
•
Modes
•
Command
Version 8.3.16.1
History
1264
(OPTIONAL) Enter one of the following interfaces to display
the interface-specific storm control configuration:
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/ port information.
EXEC
EXEC Privilege
Introduced on the MXL 10/40GbE Switch IO Module.
52
Storm Control