Service-Class Bandwidth-Percentage - Dell MXL 10GbE Reference Manual

Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Usage To apply dot1p-queue-mapping, use the service-class dynamic dot1p
Information
command.
Related service-class dot1p-mapping
Commands the switch.

service-class bandwidth-percentage

Specify a minimum bandwidth for queues.
Syntax
service-class bandwidth-percentage queue0 number queue1 number
queue2 number queue3 number
Parameters
number
Defaults none
Command CONFIGURATION
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage Guarantee a minimum bandwidth to different queues globally using the service-
Information class bandwidth-percentage command from CONFIGURATION mode. The
command is applied in the same way as the bandwidth-percentage command
in an output QoS policy. The bandwidth-percentage command in QOS-
POLICY-OUT mode supersedes the service-class bandwidth-percentage
command.
When you enable ETS, the egress QoS features in the output QoS policy-map (such
as service-class bandwidth-percentage and bandwidth-percentage),
the default bandwidth allocation ratio for egress queues are superseded by ETS
configurations. This is to provide compatibility with DCBX. Therefore, Dell
Networking OS recommends disabling ETS when you wish to apply these features
exclusively. After you disable ETS on an interface, the configured parameters are
applied.
1504
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
— displays the dot1p priority to queue mapping on
Enter the bandwidth-weight, as a percentage. The range is
from 1 to 100.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
PMUX Mode of the MXL 10/40GbE Switch I/O Module