Show Interface Ets - Dell MXL 10GbE Reference Manual

show interface ets

Displays the ETS configuration applied to egress traffic on an interface, including priority groups with
priorities and bandwidth allocation.
Syntax
show interface port-type slot/port ets {summary | detail}
Parameters
port-type slot/
port ets
{summary |
detail}
Command CONFIGURATION
Modes
Command
Version 9.3.0.0
History
Usage
To clear ETS TLV counters, use the clear ets counters interface port-
Information
type slot/port command.
The following describes the show interface summary command shown in the
following example.
Field
Interface
Max Supported
TC Group
Number of Traffic
Classes
Admin mode
Admin Parameters
Remote
Parameters
1390
Enter the port-type slot and port ETS information.
Enter the keyword summary for a summary list of results or
enter the keyword detail for a full list of results.
Introduced on the FC Flex IO module installed in the M I/O
Aggregator and MXL 10/40GbE Switch.
Description
Interface type with stack-unit and port number.
Maximum number of priority groups supported.
Number of 802.1p priorities currently configured.
ETS mode: on or off. When on, the scheduling and
bandwidth allocation configured in an ETS output policy or
received in a DCBX TLV from a peer can take effect on an
interface.
ETS configuration on local port, including priority groups,
assigned dot1p priorities, and bandwidth allocation.
ETS configuration on remote peer port, including admin
mode (enabled if a valid TLV was received or disabled),
priority groups, assigned dot1p priorities, and bandwidth
allocation. If ETS admin mode is enabled on the remote port
for DCBX exchange, the Willing bit received in ETS TLVs
from the remote peer is included.
FC Flex IO Modules