Fcoe Priority-Bits - Dell MXL 10GbE Reference Manual

To disable DCBX debugging, use the no debug dcbx command.
Parameters
{all | auto-
detect-timer |
config-exchng
| fail | mgmt |
resource | sem
| tlv}
Defaults none
Command EXEC Privilege
Modes
Command
Version 9.3.0.0
History

fcoe priority-bits

Configure the FCoE priority advertised for the FCoE protocol in application priority TLVs.
Syntax
fcoe priority-bits priority-bitmap
To remove the configured FCoE priority, use the no fcoe priority-bits
command.
Parameters
priority-bitmap
Defaults 0x8
Command PROTOCOL LLDP
Modes
Command
Version 9.3.0.0
History
Usage This command is available at the global level only.
Information
FC Flex IO Modules
Enter the type of debugging, where:
• all: enables all DCBX debugging operations.
• auto-detect-timer: enables traces for DCBX auto-
detect timers.
• config-exchng: enables traces for DCBX configuration
exchanges.
• fail: enables traces for DCBX failures.
• mgmt: enables traces for DCBX management frames.
• resource: enables traces for DCBX system resource
frames.
• sem: enables traces for the DCBX state machine.
• tlv: enables traces for DCBX TLVs.
Introduced on the FC Flex IO module installed in the M I/O
Aggregator and MXL 10/40GbE Switch
Enter the priority-bitmap range. The range is from 1 to FF.
Introduced on the FC Flex IO module installed in the M I/O
Aggregator and MXL 10/40GbE Switch
1381