Neighbor Subnet - Dell MXL 10GbE Reference Manual

neighbor subnet

Enable passive peering so that the members of the peer group are dynamic.
Syntax
neighbor peer-group-name subnet subnet-number mask
To remove passive peering, use the no neighbor peer-group-name subnet
subnet-number mask command.
Parameters
subnet-number
mask
Defaults Not configured.
Command ROUTER BGP
Modes
Command
Version 9.2(0.0)
History
neighbor timers
Set keepalive and hold time timers for a BGP neighbor or a peer group.
Syntax
neighbor {ipv6-address | peer-group-name} timers keepalive
holdtime
To return to the default values, use the no neighbor {ipv6-address | peer-
group-name} timers command.
Parameters
ipv6-address
peer-group-
name
keepalive
holdtime
IPv6 Border Gateway Protocol (IPv6 BGP)
Enter a subnet number in dotted decimal format (A.B.C.D.) as
the allowable range of addresses included in the Peer group.
To allow all addresses, enter 0::0/0.
Enter a prefix mask in / prefix-length format (/x).
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Enter the name of the peer group to set the timers for all
routers within the peer group.
Enter a number for the time interval, in seconds, between
keepalive messages sent to the neighbor routers. the range is
from 1 to 65535. the default is 60 seconds.
Enter a number for the time interval, in seconds, between
the last keepalive message and declaring the router dead.
The range is from 3 to 65535. The default is 180 seconds.
737