Protocol-Tunnel - Dell MXL 10GbE Reference Manual

in | out | both
vlan vlan-id
count value
Defaults Debug disabled.
Command EXEC Privilege
Modes
Command
Version 9.2(0.0)
History

protocol-tunnel

Enable protocol tunneling on a stacked (Q-in-Q) VLAN for specified protocol packets.
Syntax
protocol-tunnel {rate-limit rate| stp}
To disable protocol tunneling for a Layer 2 protocol, use the no protocol-
tunnel command.
Parameters
rate-limit rate
stp
Defaults none
Command CONF-IF-VLAN
Modes
Command
Version 9.2(0.0)
History
Example
Dell#conf
Dell(conf)#interface vlan 2
Dell(conf-if-vl-2)#vlan-stack compatible
Dell(conf-if-vl-2)#member Gi1/2-3
Dell(conf-if-vl-2)#protocol-tunnel stp
Dell(conf-if-vl-2)#protocol-tunnel enable
Service Provider Bridging
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Enter the keyword in, out, or both to debug incoming
interfaces, outgoing interfaces, or both incoming and
outgoing interfaces.
Enter the keyword vlan then the VLAN ID. The range is from
1 to 4094.
Enter the keyword count then the number of debug
outputs. The range is from 1 to 100.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the keyword rate-limit then a number for the rate-
limit for tunneled packets on the VMAN. The range is from
64 to 320.
Enter the keyword stp to enable protocol tunneling on a
spanning tree, including STP, MSTP, RSTP, and PVST.
Introduced on the MXL 10/40GbE Switch IO Module.
1217