Dell MXL 10GbE Reference Manual page 1485

Version 7.5.1.0
E-Series legacy
command.
ip igmp query-max-resp-time
Set the maximum query response time advertised in general queries.
Syntax
ip igmp query-max-resp-time seconds
To return to the default values, use the no ip igmp query-max-resp-time
command.
Parameters
seconds
Defaults 10 seconds
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command.
PMUX Mode of the MXL 10/40GbE Switch I/O Module
Introduced on the C-Series in Interface VLAN mode only to
enable the system to act as an IGMP Proxy Querier.
Enter the number of seconds for the maximum response
time. The range is from 1 to 25. The default is 10 seconds.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the S-Series in Interface VLAN mode only to
enable the system to act as an IGMP Proxy Querier.
Introduced on the C-Series in Interface VLAN mode only to
enable the system to act as an IGMP Proxy Querier.
1485