Table of Contents
Advertisement
•
Command
Version 8.3.16.1
History
Usage
The monitoring command is saved in the running configuration at the Monitor
Information
Session mode level and can be restored after a chassis reload.
Example
Dell# show running-config monitor session
!
monitor session 1
source TenGigabitEthernet 0/1 destination TenGigabitEthernet
0/2 direction rx
Related
monitor session
Commands
show monitor session
source (port monitoring)
Configure a port monitor source.
Syntax
source interface | range destination interface direction {rx |
tx | both}
To disable a monitor source, use the no source interface destination
interface direction {rx | tx | both} command.
Parameters
source
interface
range
destination
1048
EXEC Privilege
Introduced on the M I/O Aggregator.
— creates a session for monitoring.
— displays a monitor session.
Enter the one of the following keywords and slot/port
information:
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
•
For a VLAN interface enter the keyword VLAN then by a
number range from 1 to 4094.
•
For a port channel interface, enter the keyword LAG then
port channel and the port-channel id .
Enter the keyword range to specify a list of interfaces.
Enter the keyword destination to specify the destination
interface.
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Port Monitoring
Advertisement
Table of Contents
