Sflow Enable (Global) - Dell MXL 10GbE Reference Manual

sflow enable (Global)

Enable sFlow globally.
Syntax
sflow enable
To disable sFlow, use the no sflow enable command.
Defaults Disabled.
Command CONFIGURATION
Modes
Command
Version 8.3.16.1
History
Usage sFlow is disabled by default. In addition to this command, you must enable sFlow
Information on individual interfaces where you want sFlow sampling.
Related sflow enable (Global)
Commands
sflow enable (Interface)
Enable sFlow on interfaces.
Syntax
sflow enable
To disable sFlow, use the no sflow enable command.
Defaults Disabled.
Command INTERFACE
Modes
Command
Version 8.3.16.1
History
Usage When you enable sFlow on an interface, flow sampling is done on any traffic going
Information out of the interface.
Related sflow enable (Global)
Commands
1210
Introduced on the MXL 10/40GbE Switch IO Module.
— enables sFlow on interfaces.
Introduced on the MXL 10/40GbE Switch IO Module.
NOTE: After a physical port is a member of a LAG, it inherits the sFlow
configuration from the LAG port.
— turns sFlow on globally.
sFlow