Dell MXL 10GbE Reference Manual page 1108

Red
dscp-list
Defaults None
Command CONFIG-COLOR-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.5.0.0
Usage If the specified color-map does not exist, the Diffserv Manager (DSM) creates a
Information color map and sets all the DSCP values to green (low drop precedence).
The default setting for each DSCP value (0-63) is green (low drop
precedence). This command allows setting the number of specific DSCP values to
yellow or red.
Important Points to Remember
•
•
•
Example
Dell(conf-dscp-color-map)# dscp yellow 9,10,11,13,15,16
Related
qos dscp-color-map
Commands
qos
1108
Enter the red keyword. Traffic marked as red is dropped.
Enter a list of IP DSCP values. The dscp-list parameter
specifies the full list of IP DSCP value(s) for the specified
color. Each DSCP value in a list is separate values by commas
– no spaces (1,2,3) or indicates a list of values separated by a
hyphen (1-3). Range is 0 to 63.
Introduced on the Z9000, S6000, S4820T, S4810, and MXL.
All DSCP values that are not specified as yellow or red are colored green.
A DSCP value cannot be in both the yellow and red lists. Setting the red or
yellow list with any DSCP value that is already in the other list results in an error
and no update to that list is made.
Each color map can only have one list of DSCP values for each color; any DSCP
values previously listed for that color that are not in the new DSCP list are
colored green.
— configures the DSCP color map
dscp-color-policy— configures a DSCP color policy
Quality of Service (QoS)