Table of Contents
Advertisement
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.5(0.0)
Usage
You can use the version both command to migrate from VRRPv2 to VRRPv3. When
Information
you set the VRRP protocol version to both, the switch sends only VRRPv3
advertisements but can receive either VRRPv2 or VRRPv3 packets. To migrate an
IPv4 VRRP group from VRRPv2 to VRRPv3:
1.
2.
3.
Example
Dell(conf-if-te-0/0-vrid-100)#version ?
2
3
both
both
Dell(conf-if-te-0/0-vrid-100)#version 3
1362
Introduced on the Z9000, S6000, S4820T, S4810, and MXL.
Set the switches with the lowest priority to "both".
Set the switch with the highest priority to version to 3.
Set all the switches from both to version 3.
NOTE: Do not run VRRP version 2 and version 3 in the same group for an
extended period of time.
VRRPv2
VRRPv3
Interoperable, send VRRPv3 receive
Virtual Router Redundancy Protocol (VRRP)
Advertisement
Table of Contents
