Table of Contents
Advertisement
Command
Version 9.2(0.0)
History
Usage
The following describes the show ip pim tib command shown in the following
Information
example.
Field
(S, G)
uptime
expires
RP
flags
Incoming
interface
RPF neighbor
Outgoing
interface list:
Example
Dell#show ip pim tib
PIM Multicast Routing Table
Flags:D- Dense, S- Sparse, C- Connected, L- Local, P- Pruned,
SPT,
Advertisement,
Timers: Uptime/Expires
1032
Introduced on the MXL 10/40GbE Switch IO Module.
Description
Displays the entry in the multicast PIM database.
Displays the amount of time the entry has been in the PIM
route table.
Displays the amount of time until the entry expires and is
removed from the database.
Displays the IP address of the RP/source for this entry.
List the flags to define the entries:
•
D = PIM Dense Mode
•
S = PIM Sparse Mode
•
C = directly connected
•
L = local to the multicast group
•
P = route was pruned
•
R = the forwarding entry is pointing toward the RP
•
F = Dell Networking OS is registering this entry for a
multicast source
•
T = packets were received via Shortest Tree Path
•
J = first packet from the last hop router is received and
the entry is ready to switch to SPT
•
K = acknowledge pending state
Displays the reverse path forwarding (RPF) interface towards
the RP/ source.
Displays the next hop from this interface towards the RP/
source.
Lists the interfaces that meet one of the following criteria:
•
a directly connect member of the Group
•
statically configured member of the Group
•
received a (*,G) Join message
R- RP-bit set, F- Register flag, T- SPT-bit set, J- Join
M- MSDP created entry, A- Candidate for MSDP
K- Ack-Pending State
PIM-Sparse Mode (PIM-SM)
Advertisement
Table of Contents
