Table of Contents
Advertisement
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage
You can configure up to 16 target TCP ports on the switch in one command or
Information
multiple commands.
When you use the no iscsi target port command and the TCP port you wish
to delete is one bound to a specific IP address, the IP address value must be
included in the command.
Interfaces
The commands in this chapter are supported by Dell Networking Operating System (OS).
This chapter contains the following sections:
•
Basic Interface Commands
•
Port Channel Commands
Basic Interface Commands
The following commands are for Physical interfaces.
clear counters
Clear the counters used in the show interfaces commands for all virtual router redundancy protocol
(VRRP) groups, virtual local area networks (VLANs), and physical interfaces, or selected ones.
Syntax
clear counters interface
Parameters
interface
Defaults
Without an interface specified, the command clears all interface counters.
Command
EXEC Privilege
Modes
PMUX Mode of the MXL 10/40GbE Switch I/O Module
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
(OPTIONAL) Enter any of the following keywords and slot/
port or number to clear counters from a specified interface:
•
For the management interface on the stack-unit, enter
the keyword management ethernet followed by slot/
port information. The slot and port range is 0.
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
•
For a Port Channel interface, enter the keyword port-
channel followed by a number. Range: 1-128
1463
Advertisement
Table of Contents
