Ip Udp-Broadcast-Address - Dell MXL 10GbE Reference Manual

show ip udp-helper

ip udp-broadcast-address

Configure an IP UDP address for broadcast.
Syntax
ip udp-broadcast-address address
To delete the configuration, use the no ip udp-broadcast-address address
command.
Parameters
address
Defaults Not configured.
Command INTERFACE (config-if)
Modes
Command
Version 8.3.16.1
History
Usage When a UDP broadcast packet is flooded out of an interface, and the outgoing
Information interface is configured using this command, the outgoing packet's IP destination
address is replaced with the configured broadcast address.
Related
debug ip udp-helper
Commands
console.
show ip udp-helper
ip udp-helper udp-port
Enable the UDP broadcast feature on an interface either for all UDP ports or a specified list of UDP ports.
Syntax
ip udp-helper udp-port [udp-port-list]
To disable the UDP broadcast on a port, use the no ip udp-helper udp-port
[udp-port-list] command.
Parameters
udp-port-list
610
— displays the configured UDP helper(s) on all interfaces.
Enter an IP broadcast address in dotted decimal format
(A.B.C.D).
Enter an IP broadcast address in dotted decimal format
(A.B.C.D).
— enables debug and displays the debug information on a
— displays the configured UDP helpers on all interfaces.
(OPTIONAL) Enter up to 16 comma-separated UDP port
numbers.
NOTE: If you do not use this option, all UDP ports are
considered by default.
Interfaces