Preempt - Dell MXL 10GbE Reference Manual

Parameters
seconds
centisecs
centisecs
Defaults zero (0) seconds
Command VRRP
Modes
Command
Version 9.5(0.0)
History
Version 8.3.16.1
Usage If a switch is a MASTER and you change the hold timer, disable and re-enable VRRP
Information for the new hold timer value to take effect.
Related disable
Commands

preempt

To preempt or become the MASTER router, permit a BACKUP router with a higher priority value.
Syntax
preempt
To prohibit preemption, use the no preempt command.
Defaults Enabled (that is, a BACKUP router can preempt the MASTER router).
Command VRRP
Modes
Command
Version 8.3.16.1
History
priority
Specify a VRRP priority value for the VRRP group. The VRRP protocol uses this value during the MASTER
election process.
Syntax
priority priority
To return to the default value, use the no priority command.
Virtual Router Redundancy Protocol (VRRP)
Enter a number of seconds. The range is from 0 to 65535.
The default is zero (0) seconds.
Enter the keyword centisecs then the number of centisecs
in units of 25 centisecs. The range is from 0 to 65525 in
units of 25 centisecs.
Introduced the support for centisecs on the MXL 10/40GbE
Switch.
Introduced on the MXL 10/40GbE Switch IO Module.
— disables a VRRP group.
Introduced on the MXL 10/40GbE Switch IO Module.
1349