Fcoe Priority-Bits - Dell MXL 10GbE Reference Manual

fcoe priority-bits

Configure the FCoE priority advertised for the FCoE protocol in application priority TLVs.
Syntax
fcoe priority-bits priority-bitmap
To remove the configured FCoE priority, use the no fcoe priority-bits
command.
Parameters
priority-bitmap
Defaults 0x8
Command PROTOCOL LLDP
Modes
Command
Version 9.3.0.0
History
Usage This command is available at the global level only.
Information
fcoe-map
Create an FCoE map which contains the parameters used to configure the links between server CNAs
and a SAN fabric. Apply the FCoE map on a server-facing Ethernet port.
M I/O Aggregator and MXL 10/40GbE Switch with the FC Flex IO module
Syntax
fcoe-map map-name
Parameters
map-name
Defaults None on the MXL 10/40GbE Switch with FC Flex IO modules
On the I/O Aggregator with FC Flex IO modules, the following parameters are
applied on all the FC Flex IO module interfaces:
•
•
•
•
•
•
•
•
1410
Enter the priority-bitmap range. The range is from 1 to FF.
Introduced on the FC Flex IO module installed in the M I/O
Aggregator and MXL 10/40GbE Switch
Maximum: 32 alphanumeric characters.
Description: SAN_FABRIC
Fabric-id: 1002
Fcoe-vlan: 1002
Fc-map: 0x0efc00
Fcf-priority: 128
Fka-adv-period: 8000mSec
Keepalive: enable
Vlan priority: 3
FC Flex IO Modules