policy-map-input
Create an input policy map.
Syntax
policy-map-input policy-map-name [layer2]
To remove an input policy map, use the no policy-map-input policy-map-
name [layer2] command.
Parameters
policy-map-
name
layer2
Defaults
Layer 3
Command
CONFIGURATION
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage
The input policy map is used to classify incoming traffic to different flows using
Information
class-map, QoS policy, or incoming packets DSCP. This command enables Policy-
Map-Input Configuration mode (conf-policy-map-in).
Related
service-queue
Commands
policy-aggregate
using policy maps.
service-policy input
policy-map-output
Create an output policy map.
Syntax
policy-map-output policy-map-name
To remove a policy map, use the no policy-map-output policy-map-name
command.
Parameters
policy-map-
name
Quality of Service (QoS)
Enter the name of the policy map in character format (32
characters maximum).
(OPTIONAL) Enter the keyword layer2 to specify a Layer 2
Class Map. The default is Layer 3.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
— assigns a class map and QoS policy to different queues.
— allows an aggregate method of configuring per-port QoS
— applies an input policy map to the selected interface.
Enter the name for the policy map in character format (32
characters maximum).
1089