Service-Class Dynamic Dot1P - Dell MXL 10GbE Reference Manual

When you set the priority for a port channel, the physical interfaces assigned to the
port channel are configured with the same value. You cannot assign the dot1p-
priority command to individual interfaces in a port channel.

service-class dynamic dot1p

Honor all 802.1p markings on incoming switched traffic on an interface (from INTERFACE mode) or on all
interfaces (from CONFIGURATION mode). A CONFIGURATION mode entry supersedes an INTERFACE
mode entry.
Syntax
service-class dynamic dot1p
To return to the default setting, use the no service-class dynamic dot1p
command.
Defaults All dot1p traffic is mapped to Queue 0 unless you enable the service-class
dynamic dot1p command. The default mapping is as follows:
dot1p
0
1
2
3
4
5
6
7
Command
•
Modes
•
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage
To honor all incoming 802.1p markings on incoming switched traffic on the
Information
interface, enter this command. By default, this facility is not enabled (that is, the
802.1p markings on incoming traffic are not honored).
You can apply this command on both physical interfaces and port channels. When
you set the service-class dynamic for a port channel, the physical interfaces
1502
INTERFACE
CONFIGURATION
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
Queue ID
0
0
0
1
2
3
3
3
PMUX Mode of the MXL 10/40GbE Switch I/O Module