Vrrp For Ipv6 Commands - Dell MXL 10GbE Reference Manual

Parameters
vrrp-id
Defaults Not configured.
Command INTERFACE
Modes
Command
Version 8.3.16.1
History
Usage The VRRP group only becomes active and sends VRRP packets when a virtual IP
Information address is configured. When you delete the virtual address, the VRRP group stops
sending VRRP packets.
Related virtual-address
Command

VRRP for IPv6 Commands

The following commands apply to IPv6.
clear counters vrrp ipv6
Clear the counters recorded for IPv6 VRRP groups.
Syntax
clear counters vrrp ipv6 [vrid | vrf instance]
Parameters
vrid
vrf instance
Defaults Not configured
Command INTERFACE
Modes
Command
Version 8.3.16.1
History
Virtual Router Redundancy Protocol (VRRP)
Enter a number as the group ID. The range is from 1 to 255.
Introduced on the MXL 10/40GbE Switch IO Module.
— assigns up to 12 virtual IP addresses per VRRP group.
(OPTIONAL) Enter the number of an IPv6 VRRP group. The
range is from 1 to 255.
(OPTIONAL) Enter the name of a VRF instance (32 characters
maximum) to clear the counters of all IPv6 VRRP groups in
the specified VRF.
Introduced on the MXL 10/40GbE Switch IO Module.
1357