Table of Contents
Advertisement
Loopback 0 is up, line protocol is up
LOOPBACK, Cost: 1
Loopback interface is treated as a stub Host.
Dell>
show ip ospf neighbor
Display the OSPF neighbors connected to the local router.
Syntax
show ip ospf process-id neighbor
Parameters
process-id
Command
EXEC Privilege
Modes
Command
Version 8.3.16.1
History
Usage
The following describes the show ip ospf process-id neighbor command
Information
shown in the following example.
Item
Neighbor ID
Pri
State
Dead Time
Address
Interface
Area
Example
Dell#show ip ospf 34 neighbor
Neighbor ID Pri State
20.20.20.7
192.10.10.2 1 FULL/DR
20.20.20.1
Dell#
972
Internet Address 192.168.253.2/32, Area 0.0.0.1
Process ID 1, Router ID 192.168.253.2, Network Type
Enter the OSPF Process ID to show a specific process. If no
Process ID is entered, command applies only to the first
OSPF process.
Introduced on the MXL 10/40GbE Switch IO Module.
Description
Displays the neighbor router ID.
Displays the priority assigned neighbor.
Displays the OSPF state of the neighbor.
Displays the expected time until the system declares the
neighbor dead.
Displays the IP address of the neighbor.
Displays the interface type slot/port information.
Displays the neighbor's area (process ID).
1 FULL/DR
1 FULL/DROTHER00:00:36 192.10.10.4 Gi 0/1 0.0.0.1
Dead Time Address
00:00:32 182.10.10.3 Gi 0/0 0.0.0.2
00:00:37 192.10.10.2 Gi 0/1 0.0.0.1
Open Shortest Path First (OSPFv2 and OSPFv3)
Interface Area
Advertisement
Table of Contents
