Neighbor Maximum-Prefix - Dell MXL 10GbE Reference Manual

out
Defaults Not configured.
Command ROUTER BGPV6-ADDRESS FAMILY
Modes
Command
Version 9.2(0.0)
History

neighbor maximum-prefix

Control the number of network prefixes received.
Syntax
neighbor {ipv6-address | peer-group-name} maximum-prefix
maximum [threshold] [warning-only]
To return to the default values, use the no neighbor {ipv6-address | peer-
group-name} maximum-prefix maximum [threshold] [warning-only]
command.
Parameters
ipv6-address
peer-group-
name
maximum
threshold
warning-only
Defaults threshold = 75
Command ROUTER BGPV6-ADDRESS FAMILY
Modes
Command
Version 9.2(0.0)
History
IPv6 Border Gateway Protocol (IPv6 BGP)
Enter the keyword out to filter outbound BGP routes.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Enter the name of the peer group.
Enter a number as the maximum number of prefixes allowed
for this BGP router. The range is from 1 to 4294967295.
(OPTIONAL) Enter a number to be used as a percentage of
the maximum value. When the number of prefixes reaches
this percentage of the maximum value, the software sends a
message. The range is from 1 to 100 percent. The default is
75.
(OPTIONAL) Enter the keyword warning-only to set the
router to send a log message when the maximum value is
reached. If this parameter is not set, the router stops peering
when the maximum number of prefixes is reached.
Introduced on the MXL 10/40GbE Switch IO Module.
769