Show Ip Tcp Initial-Time - Dell MXL 10GbE Reference Manual

Parameters
<8-75>
Command
CONFIGURATION
Modes
Command
Version 9.3(0.0)
History
Usage You can configure the amount of time for which the device must wait before it
Information attempts to establish a TCP connection. Using this capability, you can limit the wait
times for TCP connection requests. Upon responding to the initial SYN packet that
requests a connection to the router for a specific service (such as SSH or BGP) with
a SYN ACK, the router waits for a period of time for the ACK packet to be sent from
the requesting host that will establish the TCP connection.

show ip tcp initial-time

Displays the interval that you configured for the device to wait before the TCP connection is attempted to
be established. This command is supported on the MXL switch.
Syntax
show ip tcp initial-time
Command
EXEC
Modes
EXEC Privilege
Command
Version 9.3(0.0)
History
ip unreachables
Enable the generation of internet control message protocol (ICMP) unreachable messages.
Syntax
ip unreachables
To disable the generation of ICMP messages, use the no ip unreachables
command.
Defaults Disabled.
Command INTERFACE
Modes
634
Wait duration in seconds for the TCP connection to be
established.
Introduced on the MXL platform.
Introduced on the MXL 10/40GbE Switch IO Module
platform.
IPv4 Routing