Tunneling - Dell MXL 10GbE Reference Manual

Tunneling

Tunneling is supported on the MXL platform.
tunnel-mode
Enable a tunnel interface.
Syntax
tunnel mode {ipip | ipv6 | ipv6ip}[decapsulate-any]
To disable an active tunnel interface, use the no tunnel mode command.
Parameters
ipip
ipv6
ipv6ip
decapsulate-
any
Defaults None
Command INTERFACE TUNNEL
Modes
Command
Version 9.4(0.0)
History
Version 9.2(0.0)
Usage
To enable a tunnel interface, use this command. You must define a tunnel mode
Information
for the tunnel to function. If you previously defined the tunnel destination or
source address, the tunnel mode must be compatible.
Including the decapsulate-any option causes the command to fail if any of the
following tunnel transmit options are configured: tunnel destination, tunnel dscp,
tunnel flow-label, tunnel hop-limit, or tunnel keepalive. Conversely, if you
configure any tunnel allow-remote entries, the tunnel—mode command fails
unless the decapsulate-any option is included
1296
Enable tunnel in RFC 2003 mode and encapsulate IPv4
and/or IPv6 datagrams inside an IPv4 tunnel.
Enable tunnel in RFC 2473 mode and encapsulate IPv4
and/or IPv6 datagrams inside an IPv6 tunnel.
Enable tunnel in RFC 4213 mode and encapsulate IPv6
datagrams inside an IPv4 tunnel.
(Optional) Enable tunnel in multipoint receive-only mode.
Added the decapsulate-any command.
Introduced on the MXL 10/40GbE Switch IO Module.
55
Tunneling