Ip Ospf Cost - Dell MXL 10GbE Reference Manual

ip ospf cost

Change the cost associated with the OSPF traffic on an interface.
Syntax
ip ospf cost cost
To return to default value, use the no ip ospf cost command.
Parameters
cost
Defaults The default cost is based on the reference bandwidth.
Command INTERFACE
Modes
Command
Version 8.3.16.1
History
Usage
If this command is not configured, cost is based on the auto-cost command.
Information
When you configure OSPF over multiple vendors, to ensure that all routers use the
same cost, use the ip ospf cost command. Otherwise, OSPF routes improperly.
Related auto-cost
Commands
ip ospf dead-interval
Set the time interval since the last hello-packet was received from a router. After the interval elapses, the
neighboring routers declare the router dead.
Syntax
ip ospf dead-interval seconds
To return to the default values, use the no ip ospf dead-interval command.
Parameters
seconds
Defaults 40 seconds
Command INTERFACE
Modes
Command
Version 8.3.16.1
History
Usage By default, the dead interval is four times the default hello-interval.
Information
940
Enter a number as the cost. The range is from 1 to 65535.
Introduced on the MXL 10/40GbE Switch IO Module.
— controls how the OSPF interface cost is calculated.
Enter the number of seconds for the interval. The range is
from 1 to 65535. The default is 40 seconds.
Introduced on the MXL 10/40GbE Switch IO Module.
Open Shortest Path First (OSPFv2 and OSPFv3)