Storm-Control Broadcast (Interface) - Dell MXL 10GbE Reference Manual

storm-control broadcast (Interface)

Configure the percentage of broadcast traffic allowed on an interface.
Syntax
storm-control broadcast [packets_per_second in]
To disable broadcast storm control on the interface, use the no storm-control
broadcast [packets_per_second in] command.
Parameters
packets_per_se
cond
Defaults none
Command INTERFACE (conf-if-interface-slot/port)
Modes
Command
Version 8.3.16.1
History
storm-control multicast (Configuration)
Configure the packets per second (pps) of multicast traffic.
Syntax
storm-control multicast packets_per_second in
To disable storm-control for multicast traffic into the network, use the no storm-
control multicast packets_per_second in command.
Parameters
packets_per_se
cond
Defaults none
Command CONFIGURATION (conf)
Modes
Command
Version 8.3.16.1
History
Usage Broadcast traffic (all 0xFs) should be counted against the broadcast storm control
Information meter, not against the multicast storm control meter. It is possible, however, that
some multicast control traffic may get dropped when storm control thresholds are
exceeded.
Storm Control
Enter the packets per second of broadcast traffic allowed
into the network. The range is from 0 to 33554368.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the packets per second of multicast traffic allowed into
the network. The range is from 0 to 33554368.
Introduced on the MXL 10/40GbE Switch IO Module.
1267