Table of Contents
Advertisement
Parameters
number
all
Defaults
No downstream links are disabled when an upstream link in an uplink-state group
goes down.
Command
UPLINK-STATE-GROUP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
Version
8.3.19.0
Version
8.3.12.0
Version 8.4.2.3
Usage
A user-configurable number of downstream interfaces in an uplink-state group are
Information
put into a link-down state with an UFD-Disabled error message when one
upstream interface in an uplink-state group goes down.
If all upstream interfaces in an uplink-state group go down, all downstream
interfaces in the same uplink-state group are put into a link-down state.
Related
•
Commands
•
enable
Enable uplink state group tracking for a specific UFD group.
Syntax
enable
To disable upstream-link tracking without deleting the uplink-state group, use the
no enable command.
Defaults
Upstream-link tracking is automatically enabled in an uplink-state group.
PMUX Mode of the MXL 10/40GbE Switch I/O Module
Enter the number of downstream links to be brought down
by UFD. The range is from 1 to 1024.
Brings down all downstream links in the group.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the S-Series S50.
downstream
— assigns a port or port-channel to the uplink-state group as a
downstream interface.
uplink-state-group
— creates an uplink-state group and enables the tracking of
upstream links.
1525
Advertisement
Table of Contents
