Dell MXL 10GbE Reference Manual page 1533

Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
Version 9.1(0.0)
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.4.1.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command
Usage
Dell Networking OS supports up to 16 SNMP trap receivers.
Information
If you do not configure this command, no traps controlled by this command are
sent. If you do not specify a notification-type and notification-option,
all traps are enabled.
snmp-server host
Configure the recipient of an SNMP trap operation.
Syntax
snmp-server host ip-address | ipv6-address
To remove the SNMP host, use the no snmp-server host ip-address
command.
Parameters
ip-address
ipv6-address
PMUX Mode of the MXL 10/40GbE Switch I/O Module
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Added support for copy-config and ecmp traps.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for VRRP traps.
Added support for STP and xSTP traps. Introduced on the S-
Series.
Introduced on the C-Series.
Enter the keyword host then the IP address of the host
(configurable hosts is limited to 16).
Enter the keyword host then the IPv6 address of the host in
the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zero.
1533