Ip Igmp Snooping Last-Member-Query-Interval - Dell MXL 10GbE Reference Manual

Defaults Enabled.
Command CONFIGURATION
Modes
Command
Version 8.3.16.1
History
Usage
When you disable flooding, unregistered multicast data traffic is forwarded to only
Information
multicast router ports, both static and dynamic, in a VLAN. If there is no multicast
router port in a VLAN, unregistered multicast data traffic is dropped.
On the MXL switch, when you configure no ip igmp snooping flood, the
system forwards the frames on mrouter ports for first 96 IGMP snooping enabled
VLANs. For all other VLANs, unregistered multicast packets are dropped.

ip igmp snooping last-member-query-interval

The last member query interval is the maximum response time inserted into Group-Specific queries sent
in response to Group-Leave messages.
Syntax
ip igmp snooping last-member-query-interval milliseconds
To return to the default value, use the no ip igmp snooping last-member-
query-interval command.
Parameters
milliseconds
Defaults 1000 milliseconds
Command INTERFACE VLAN
Modes
Command
Version 8.3.16.1
History
Usage This last-member-query-interval is also the interval between successive Group-
Information Specific Query messages. To change the last-member-query interval, use this
command.
ip igmp snooping mrouter
Statically configure a VLAN member port as a multicast router interface.
Syntax
ip igmp snooping mrouter interface interface
550
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the interval in milliseconds. The range is from 100 to
65535. The default is 1000 milliseconds.
Introduced on the MXL 10/40GbE Switch IO Module.
Internet Group Management Protocol (IGMP)