Vlan 2–100, Port 1–25
Dell(config-if-range)# no shutdown
Dell(config-if-range)#
Related
interface port-channel
Commands
interface vlan
show config (from INTERFACE RANGE mode)
interfaces.
show range
interface vlan
Configure a VLAN. You can configure up to 4096 VLANs.
Syntax
interface vlan vlan-id
To delete a VLAN, use the no interface vlan vlan-id command.
Parameters
vlan-id
Defaults
Not configured, except for the Default VLAN, which is configured as VLAN 1.
Command
CONFIGURATION
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage
For more information about VLANs and the commands to configure them, refer to
Information
the Virtual LAN (VLAN) Commands.
FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC/IP ACLs are
not supported.
Example
Dell(conf)#int vlan 3
Dell(conf-if-vl-3)#
Related
interface
Commands
interface port-channel
PMUX Mode of the MXL 10/40GbE Switch I/O Module
— configures a port channel group.
— configures a VLAN interface.
— shows the bulk configuration ranges.
Enter a number as the VLAN Identifier. The range is from 1 to
4096.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
— configures a physical interface.
— configures a port channel group.
— shows the bulk configuration
1471