Table of Contents
Advertisement
You cannot add an interface to a Port Channel if the interface contains an IP
address in its configuration.
Link MTU and IP MTU considerations for Port Channels are:
•
•
When an interface is removed from a Port Channel with the no channel-member
command, the interface reverts to its configuration prior to joining the Port
Channel.
An interface can belong to only one Port Channel.
You can add up to 16 interfaces to a Port Channel on the MXL switch. The
interfaces can be located on different line cards but must be the same physical
type and speed (for example, all 10-Gigabit Ethernet interfaces). However, you can
combine 100/1000 interfaces and GE interfaces in the same Port Channel.
If the Port Channel contains a mix of interfaces with 100 Mb/s speed and 1000
Mb/s speed, the software disables those interfaces whose speed does not match
the speed of the first interface configured and enabled in the Port Channel. If that
first interface goes down, the Port Channel does not change its designated speed;
disable and re-enable the Port Channel or change the order of the channel
members configuration to change the designated speed. If the Port Channel
contains a mix of interfaces with 100 Mb/s speed and 1000 Mb/s speed, the
software disables those interfaces whose speed does not match the speed of the
first interface configured and enabled in the Port Channel. If that first interface
goes down, the Port Channel does not change its designated speed; disable and
re-enable the Port Channel or change the order of the channel members
configuration to change the designated speed. For more information about Port
Channels, refer to the Dell Networking OS Configuration Guide.
Related
description
Commands
interface port-channel
shutdown
interface port-channel
Create a Port Channel interface, which is a link aggregation group (LAG) containing 16 physical interfaces
on the XML switch.
Syntax
interface port-channel channel-number
To delete a Port Channel, use the no interface port-channel channel-
number command.
1480
All members must have the same link MTU value and the same IP MTU value.
The Port Channel link MTU and IP MTU must be less than or equal to the link
MTU and IP MTU values configured on the channel members. For example, if
the members have a link MTU of 2100 and an IP MTU 2000, the Port Channel's
MTU values cannot be higher than 2100 for link MTU or 2000 bytes for IP MTU.
— assigns a descriptive text string to the interface.
— creates a Port Channel interface.
— disables/enables the port channel.
PMUX Mode of the MXL 10/40GbE Switch I/O Module
Advertisement
Table of Contents
