Debug Dcbx - Dell MXL 10GbE Reference Manual

Defaults Auto
Command INTERFACE PROTOCOL LLDP
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage
DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Information
Configure DCBX operation at the INTERFACE level on a switch or globally on the
switch. To verify the DCBX configuration on a port, use the show interface
dcbx detail command.

debug dcbx

Enable DCBX debugging.
Syntax
debug dcbx {all | auto-detect-timer | config-exchng | fail |
mgmt | resource | sem | tlv}
To disable DCBX debugging, use the no debug dcbx command.
Parameters
{all | auto-
detect-timer |
config-exchng
| fail | mgmt |
resource | sem
| tlv}
Defaults none
Command EXEC Privilege
Modes
Command
Version 9.2(0.0)
History
1432
• ieee-v2: configures the port to use IEEE 802.1az (Draft
2.5).
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the type of debugging, where:
• all: enables all DCBX debugging operations.
• auto-detect-timer: enables traces for DCBX auto-
detect timers.
• config-exchng: enables traces for DCBX configuration
exchanges.
• fail: enables traces for DCBX failures.
• mgmt: enables traces for DCBX management frames.
• resource: enables traces for DCBX system resource
frames.
• sem: enables traces for the DCBX state machine.
• tlv: enables traces for DCBX TLVs.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
PMUX Mode of the MXL 10/40GbE Switch I/O Module