Dell MXL 10GbE Reference Manual page 1539

Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command
Usage When you decrease the buffer size, all messages stored in the buffer are lost.
Information Increasing the buffer size does not affect messages stored in the buffer.
Related
clear logging
Commands
show logging
buffer.
logging console
Specify which messages are logged to the console.
Syntax
logging console [level]
To return to the default values, use the default logging console command.
To disable logging to the console, use the no logging console command.
Parameters
level
Defaults level = 7; size = debugging
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
Version
8.3.19.0
Version 8.3.11.1
PMUX Mode of the MXL 10/40GbE Switch I/O Module
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
— clears the logging buffer.
— displays the logging setting and system messages in the internal
(OPTIONAL) Indicate a value from 0 to 7 or enter one of the
following parameters: emergencies, alerts, critical,
errors, warnings, notifications, informational, or
debugging. The default is 7 or debugging.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S4820T.
Introduced on the Z9000.
1539