Igmp Snooping Commands - Dell MXL 10GbE Reference Manual

ip igmp version
Manually set the version of the router to IGMPv2 or IGMPv3.
Syntax
ip igmp version {2 | 3}
Parameters
2
3
Defaults 2 (that is, IGMPv2)
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version 9.2(0.0)
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Version 7.5.1.0

IGMP Snooping Commands

Dell Networking OS supports IGMP Snooping version 2 and 3 on all Dell Networking systems.
Important Points to Remember for IGMP Snooping
• Dell Networking OS supports version 1, version 2, and version 3 hosts.
• Dell Networking OS IGMP snooping implementation is based on IP multicast address (not based on
Layer 2 multicast mac address) and the IGMP snooping entries are in Layer 3 flow table not in Layer 2
forwarding information base (FIB).
• Dell Networking OS IGMP snooping implementation is based on draft-ietf-magma-snoop-10.
• Dell Networking OS supports IGMP snooping on JUMBO-enabled cards.
• IGMP snooping is not enabled by default on the switch.
• A maximum of 1800 groups and 600 VLAN are supported.
1486
Enter the number 2 to set the IGMP version number to
IGMPv2.
Enter the number 3 to set the IGMP version number to
IGMPv3.
Introduced on the S6000.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
PMUX Mode of the MXL 10/40GbE Switch I/O Module