Dell MXL 10GbE Reference Manual page 839

level-2
interval
seconds
initial_wait_inte
rval seconds
second_wait_i
nterval seconds
Defaults Refer to Parameters.
Command
•
Modes
•
Command
Version 9.2(0.0)
History
Usage
This command spf-interval in CONFIG-ROUTER-ISIS-AF-IPV6 mode is used
Information
for IPv6 Multi-Topology route computation only. If using Single Topology mode,
use the spf-interval command in CONFIG-ROUTER-ISIS mode for both IPv4
and IPv6 route computations.
SPF throttling slows down the frequency at which route calculations are performed
during network instability. Even though throttling route calculations slows down
network convergence, not throttling can result in a network not functioning as
expected. If network topology is unstable, throttling slows down the scheduling of
route calculations until the topology regains its stability.
The first route calculation is controlled by the initial wait interval and the second
calculation is controlled by the second wait interval. Each subsequent wait interval
is twice as long as the previous one until the wait interval reaches the maximum
wait time specified (interval seconds). After the network calms down and there
are no triggers for two times the maximum interval, fast behavior is restored (the
initial wait time).
Intermediate System to Intermediate System (IS-IS)
(OPTIONAL) Enter the keyword level-2 to apply the
configuration to Level-2 SPF calculations.
Enter the maximum number of seconds between SPF
calculations. The range is from 0 to 120 seconds. The default
is 10 seconds.
(OPTIONAL) Enter the initial wait time, in seconds, before
running the first SPF calculations. The range is from 0 to 120
seconds. The default is 5 seconds.
(OPTIONAL) Enter the wait interval, in seconds, between the
first and second SPF calculations. The range is from 0 to 120
seconds. The default is 5 seconds.
ROUTER ISIS (for IPv4)
CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Introduced on the MXL 10/40GbE Switch IO Module.
839