Spanning Tree Protocol (Stp) - Dell MXL 10GbE Reference Manual

Spanning Tree Protocol (STP)

The commands in this chapter configure and monitor the IEEE 802.1d spanning tree protocol (STP).
bridge-priority
Set the bridge priority of the switch in an IEEE 802.1D spanning tree.
Syntax
bridge-priority {priority-value | primary | secondary}
To return to the default value, use the no bridge-priority command.
Parameters
priority-value
primary
secondary
Defaults priority-value = 32768
Command SPANNING TREE (The prompt is "config-stp".)
Modes
Command
Version 8.3.16.1
History
debug spanning-tree
Enable debugging of the spanning tree protocol and view information on the protocol.
Syntax
debug spanning-tree {stp-id [all | bpdu | events | exceptions]
| protocol}
To disable debugging, use the no debug spanning-tree command.
Parameters
stp-id
1270
Enter a number as the bridge priority value. The range is
from 0 to 65535. The default is 32768.
Enter the keyword primary to designate the bridge as the
root bridge.
Enter the keyword secondary to designate the bridge as a
secondary root bridge.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter zero (0). The switch supports one spanning tree group
with a group ID of 0.
53
Spanning Tree Protocol (STP)