Vlan-Stack Trunk - Dell MXL 10GbE Reference Manual

Parameters
number
Defaults 0x9100
Command CONFIGURATION
Modes
Command
Version 8.3.16.1
History
Usage
For specific interoperability limitations regarding the S-Tag TPID, refer to the Dell
Information
Networking OS Configuration Guide.
Related
portmode hybrid
Commands
untagged frames. A port configured this way is identified as a hybrid port in report
displays.

vlan-stack trunk

Stackable VLAN network.
vlan-stack trunk
Specify a Layer 2 port or port channel as a trunk port to the Stackable VLAN network.
Syntax
vlan-stack trunk
To remove a trunk port designation from the selected interface, use the no vlan-
stack trunk command.
Defaults Not configured.
Command INTERFACE
Modes
Command
Version 8.3.16.1
History
Usage
Prior to using this command, to place the interface in Layer 2 mode, execute the
Information
switchport command.
To remove the trunk port designation, first remove the port (using the no member
interface command) from all stackable VLAN-enabled VLANs.
Starting with the Dell Networking OS version 7.8.1.0, a VLAN-Stack trunk port is
also allowed to be configured as a tagged port and as an untagged port for single-
1328
Enter the hexadecimal number as the stackable VLAN tag.
You may specify both bytes of the 2-byte S-Tag TPID. The
range is from 0 to FFFF. The default is 9100.
Introduced on the MXL 10/40GbE Switch IO Module.
— sets a port (physical ports only) to accept both tagged and
— specifies a Layer 2 port or port channel as a trunk port to the
Introduced on the MXL 10/40GbE Switch IO Module.
VLAN Stacking