Dell MXL 10GbE Reference Manual page 1376

dcbmapABC
dcbmapXYZ
Dell# show dcb-map dcbmapABC
Priority-Group Table:
Priority-Group
0
1
2
3
5
6
7
PFC Enabled priorities: 3, 4
Related
dcb-map
Commands
that support converged Ethernet traffic.
show qos dcb-map
Display the DCB parameters configured in a specified DCB map.
FC Flex IO Modules with MXL
Syntax
show qos dcb-map map-name
Parameters
map-name
Command
•
Modes
•
Command
Version 9.3(0.0)
History
Usage
Use the show qos dcb-map command to display the enhanced transmission
Information
selection (ETS) and priority-based flow control (PFC) parameters used to configure
server-facing Ethernet ports.
The following table describes the show qos dcb-map output shown in the
example below.
Field
State
PFC Mode
PG
1376
te 0/1
te 0/2
0,1,2,5,6,7
3
4
-
-
-
-
— creates a DCB map to configure DCB parameters on Ethernet ports
Displays the PFC and ETS parameters configured in the
specified map.
EXEC
EXEC Privilege
Introduced on the FC Flex IO module installed in the MXL
10/40GbE Switch.
Description
Complete: All mandatory DCB parameters are correctly
configured. In progress: The DCB map configuration is not
complete. Some mandatory parameters are not configured.
PFC configuration in DCB map: On (enabled) or Off.
Priority group configured in the DCB map.
Active
Not active
Priorities
50
30
20
Bandwidth(%)
FC Flex IO Modules