Snmp-Server Group - Dell MXL 10GbE Reference Manual

Defaults As above.
Command CONFIGURATION
Modes
Command
Version 8.3.16.1
History
Usage
Changing the value of the SNMP Engine ID has important side effects. A user's
Information
password (entered on the command line) is converted to a message digest
algorithm (MD5) or secure hash algorithm (SHA) security digest. This digest is based
on both the password and the local Engine ID. The command line password is then
destroyed, as required by RFC 2274. Because of this deletion, if the local value of
the Engine ID changes, the security digests of SNMPv3 users is invalid and you
must reconfigure the users.
For the remote Engine ID, the host IP and UDP port are the indexes to the
command that are matched to either overwrite or remove the configuration.
Related
show snmp engineID
Commands
are configured on the router.
show running-config

snmp-server group

Configure a new SNMP group or a table that maps SNMP users to SNMP views.
Syntax
snmp-server group [group_name {1 | 2c | 3 {auth | noauth |
priv}}] [read name] [write name] [notify name] [ access-list-
name | access-list-name]]
To remove a specified group, use the no snmp-server group [group_name
{v1 | v2c | v3 {auth | noauth | priv}}] [read name] [write
name] [notify name] [access-list-name | access-list-name]]
command.
Parameters
group_name
1 | 2c | 3
Simple Network Management Protocol (SNMP) and Syslog
Introduced on the MXL 10/40GbE Switch IO Module.
— displays the SNMP engine and all the remote engines that
— displays the SNMP running configuration.
Enter a text string (up to 20 characters long) as the name of
the group. The following groups are created for mapping to
read/write community/security-names (defaults):
• v1v2creadg — maps to a community/security-name
with ro permissions.
• 1v2cwriteg — maps to a community/security-name rw
permissions.
(OPTIONAL) Enter the security model version number (1, 2c,
or 3):
1229