Tunnel Source - Dell MXL 10GbE Reference Manual

Configuration of IPv6 commands over decapsulate-any tunnel causes an error.

tunnel source

Set a source address for the tunnel.
Syntax
tunnel source {ip-address | ipv6–address | interface-type-
number}
To delete the current tunnel source address, use the no tunnel source
command.
Parameters
ip-address
ipv6–address
interface-type-
number
Defaults none
Command INTERFACE TUNNEL (conf-if-tu)
Modes
Command
Version 9.2(0.0)
History
Usage
If you configure a tunnel interface or destination address, the tunnel source must
Information
be compatible.
If you configure a tunnel source address as an interface, the tunnel does not
function until the compatible address is present on the particular interface.
Tunneling
Enter the source IPv4 address in A.B.C.D format.
Enter the source IPv6 address in X:X:X:X::X format.
• For a 100/1000 Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a 1–Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel then a number from 1 to 128.
• For a 10–Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Introduced on the MXL 10/40GbE Switch IO Module.
1297