Ip Pim Sparse-Mode - Dell MXL 10GbE Reference Manual

Command
Version 9.2(0.0)
History
Usage Priority is stored at BSR router when receiving a Candidate-RP-Advertisement.
Information

ip pim sparse-mode

Enable PIM sparse mode and IGMP on the interface.
Syntax
ip pim sparse-mode
To disable PIM sparse mode and IGMP, use the no ip pim sparse-mode
command.
Defaults Disabled.
Command INTERFACE
Modes
Command
Version 9.2(0.0)
History
Usage The interface must be enabled (the no shutdown command) and not have the
Information
switchport command configured. Multicast must also be enabled globally (using
the ip multicast-lag-hashing command). PIM is supported on the port-
channel interface.
ip pim sparse-mode sg-expiry-timer
Enable expiry timers globally for all sources, or for a specific set of (S,G) pairs an access list defines.
Syntax
ip pim sparse-mode sg-expiry-timer seconds [access-list name]
To disable configured timers and return to default mode, use the no ip pim
sparse-mode sg-expiry-timer command.
Parameters
seconds
access-list
name
Defaults Disabled. The default expiry timer (with no times configured) is 210 sec.
PIM-Sparse Mode (PIM-SM)
Introduced on the MXL 10/40GbE Switch IO Module.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the number of seconds the S, G entries are retained.
The range is from 211 to 86400.
(OPTIONAL) Enter the name of a previously configured
Extended ACL to enable the expiry time to specified S,G
entries.
1021