Neighbor Filter-List - Dell MXL 10GbE Reference Manual

Parameters
ipv6-address
peer-group-
name
prefix-list-
name
in
out
Defaults Not configured.
Command ROUTER BGPV6-ADDRESS FAMILY
Modes
Command
Version 9.2(0.0)
History
Related

neighbor filter-list

Commands
neighbor route-map
neighbor filter-list
Configure a BGP filter based on the AS-PATH attribute.
Syntax
neighbor [ipv6-address | peer-group-name] filter-list aspath
access-list-name [in | out]
To delete a BGP filter, use the no neighbor [ipv6-address | peer-group-
name] filter-list aspath access-list-name [in | out] command.
Parameters
ipv6-address
peer-group-
name
access-list-
name
in
768
Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Enter the name of the peer group.
Enter the name of an established prefix list. If the prefix list is
not configured, the default is permit (to allow all routes).
Enter the keyword in to distribute only inbound traffic.
Enter the keyword out to distribute only outbound traffic.
Introduced on the MXL 10/40GbE Switch IO Module.
— assigns a AS-PATH list to a neighbor or peer group.
— assigns a route map to a neighbor or peer group.
Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Enter the name of the peer group to apply the filter to all
routers in the peer group.
Enter the name of an established AS-PATH access list. If the
AS-PATH access list is not configured, the default is permit
(to allow routes).
Enter the keyword in to filter inbound BGP routes.
IPv6 Border Gateway Protocol (IPv6 BGP)