Ip Pim Dr-Priority - Dell S4810 Reference Manual

hash-mask-
length
priority
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 6.1.1.0

ip pim dr-priority

Change the designated router (DR) priority for the interface.
S4810
Syntax
ip pim dr-priority priority-value
To remove the DR priority value assigned, use the no ip pim dr-priority
command.
Parameters
priority-value
Defaults 1
PIM-Sparse Mode (PIM-SM)
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from
1 to 4094.
(OPTIONAL) Enter the hash mask length. The range is from
zero (0) to 32. The default is 30.
(OPTIONAL) Enter the priority used in Bootstrap election
process. The range is from zero (0) to 255. The default is
zero (0).
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Added support for the VLAN interface.
Enter a number. Preference is given to larger/higher number.
The range is from 0 to 4294967294. The default is 1.
1285